Laminate floors with the click system are a popular choice for many people when renovating or building a house. Their installation is relatively simple and can be completed even by those who do not have much experience in handicrafts. In this article, we will go through the procedure of how to correctly lay a laminate floor with the click system, in order to achieve a professional result.
Preparation of Materials and Tools
Laminate boards: Buy enough laminate boards with the same color shade and pattern.
Underlay under the laminate: A soft underlay helps reduce noise and level the surface. Choose a mat made for laminate floors.
Measuring tape, trimmer: For precise measuring and trimming of boards in places around walls and transitions.
Hammer, roller and nails: For joining boards and creating an even surface.
Approach
Preparation of the background
Before starting the installation, make sure that the substrate is clean, dry and smooth. Remove the old floor and unevenness.
Installing the pad
Place a soft mat over the entire floor area. Tape the strips of the mat together so they don't move during installation.
Start in the middle of the room
Start the installation in the middle of the room and gradually work towards the walls. This will allow for an even distribution of the boards.
Lay the first board
Place the first board with the click system against the long wall of the room. Make sure the small tab on the board is pointing towards the wall. Leave a small gap between the board and the wall to allow the wood to stretch.
Click and fasten
Slide the next board with the click system into the first board. Check that the boards are well connected. Use nails to gently separate the boards from the wall to make room for the expansion gap.
Proceed step by step
Continue inserting other boards gradually up to the wall. Use nails to maintain a constant gap between the wall and the boards.
Trim at transition points
When installing around doors, arches, or other transitions, carefully measure and cut boards as needed.
The last row of boards:
The last row of boards often needs to be trimmed to width. Make sure you have enough expansion gap on this side of the room as well.
Fixing the last boards
You can fasten the last boards with a hammer and nails. Make sure they are firmly connected and that the expansion gap is maintained.
Finishing work
After installation, remove the adhesive tape from the mat and prepare the surface thoroughly.
The correct installation of a laminate floor with the click system requires precision and patience. By following this step-by-step guide, you should be able to achieve a professional result. Do not forget to properly prepare the substrate and observe the expansion gaps to avoid problems in the future. With a new laminate floor, you can enjoy a beautiful and practical surface in your home.